Multicooker repair at home in Shaykhantakhur

If the multicooker turns on but won't heat, or heating is very weak — the heating element has likely failed. The technician removes the bowl, checks element resistance with a multimeter, inspects contacts and the temperature sensor. If needed, we replace the element with a compatible or original part.

Heating element replacement from 150,000 UZS depending on model. Work is done on site in 1–2 hours. We explain why the element failed (scale from water, voltage spike) and how to extend the appliance's life: don't pour cold water into a hot bowl, use a voltage stabilizer.

Won't turn on, display won't light, buttons don't respond, or an error code appears — the control board is often the cause. The technician checks the power supply, capacitors, processor, and button panel. Individual components (capacitors, resistors) can be soldered on site; a failed processor may need a full board swap.

Board repair from 120,000 UZS; board replacement from 200,000 UZS. We work with Redmond, Polaris, Philips — original and compatible boards. After repair, we test all modes and explain how to avoid a repeat: don't wash the board with water, use a voltage stabilizer.

Steam escaping from the lid, pressure won't build, or the valve keeps hissing — the lid seal, pressure relief valve, or sensor may be at fault. The technician inspects the silicone seal for cracks and deformation, checks the valve for blockages and spring, and tests the pressure sensor.

Seal replacement from 80,000 UZS; valve from 100,000 UZS; pressure sensor from 120,000 UZS. Most work on site. We show how to care for the lid: wash the seal after each use, don't store the lid closed so the silicone doesn't deform.